Los Angeles Trenchless Pipe Lining
A Non-Invasive Option to Pipe Repair
Trenchless pipe lining, also referred to as a cured-in-place pipe (CIPP), is where a pipe is created within the existing pipe with special epoxy resins. Pipe liner will cover separated joints or cracks in the existing pipe while reinforcing the structural strength of the new pipes. Using our high-tech equipment, our professional team at Mr. Sewer Rooter can do this without ripping up your lawn, driveway, hardscaping, or your gorgeous landscaping.
Our Trenchless Pipe Lining Process
Mr. Sewer Rooter takes pride in being one of the leading sewer service companies to offer this non-invasive option for pipe repair.
See below our step-by-step process of trenchless pipe lining in Los Angeles:
- Find the problem – Our technicians will accurately determine the pipe that needs to be “lined.” Once they have accurately diagnosed the pipes, they’ll carefully dig only one small hole to install the pipe liner. Just like you’ve heard that minimally invasive surgery doesn’t leave scars, you’ll say that Mr. Sewer Rooter didn’t leave any scars either.
- Clean the pipe to prep for pipe liner – Before installing the pipe liner, our technicians will have to clean out all roots or debris from the pipe in order to return the pipe back to its original functioning diameter whether it is a 4-inch drain pipe or a 6-inch sewer line. To do this, our rooters will use the hydro jetter, which utilizes highly-pressurized water (up to 4,000 psi) to clean the pipe.
- Install the pipe liner – Once the pipe is cleaned and cleared from roots and debris, the technicians are ready to install the pipe liner. They will measure the length of the pipe that needs to be lined and cut it to that specific length. Once the liner is cut, a two-part epoxy is mixed (one of them being the activator, which causes the epoxy to harden) and poured into the felt liner. The liner, which is saturated with the epoxy resin, is then installed into the existing pipe, the bladder or “balloon” is inflated afterward and then the curing begins. Usually, it takes about one hour and 30 minutes for the resin to harden and cure, but this time depends on both temperature and length. Once cured, the “balloon” is pulled out, leaving a complete structural pipe within your existing pipe.
- Inspection – To ensure that the job was done right, our technicians will run a video camera down the pipe to inspect the work. You will receive a DVD recording of this as well.
Whether you have a 3-inch, 4-inch, or 6-inch lines, Mr. Sewer Rooter can handle it. We also offer a 10-year warranty for trenchless pipe lining in Los Angeles.
Honest & Dependable Technicians
Open communication and quality work on every job.
All Work Done In-House
All work performed by our own people and equipment.
Family Owned & Operated Business
Serving the Los Angeles community since 1990.